CMA Ink series is NC Maleic based Flexo ink. CMA has an excellent printability on Treated woven laminated bags and a very good color reproduction.
PRINTING: Flexo Printing Process.
APPLICATION: This ink is specially designed for treated woven laminated bags.
SUBSTRATES: Corona treated OPP films (treatment not less than 380 mN / cm)
For printing on other substrates not mentioned above please contact with representative of EASTLAND INK.
Characteristics:
Excellent Mileage
Very good after printing results like rubbing, Scratch Properties.
Excellent Gloss.
Excellent Adhesion.
Excellent heat resistant properties.
PRESS CONDITION: Machine Speed = 60-250 m/min
Machine Temp. = 50 – 70°C
REDUCERS: Reducers used for CMA Ink series is mentioned below.
IPA: Ethyl Acetate (85:15) Flexo Process.
GLYCOL acts as retarder even if 3:1 Blend of solvent is too fast. However, it should not be used more than10%. For any problem during printing please contact with representative of EASTLAND INKS.
Color range: CMA ink series is available in wide variety of color range. However, on demand special colors can be developed. Pigments used have good light fastness, however extensive exposure of direct sunlight is not recommended. For requirement of such characteristics kindly consult our Representative.
Important Note: Information’s given above is based on experience at Machines and after necessary laboratory testing. However, the product’s performance and its suitability for the customer’s purchase depend on the particular conditions of use and the material being printed. We recommend that customer satisfy themselves that each product meets their requirements in all respects before commencing a print run. Since we cannot anticipate or control the conditions under which our products are used, it is not possible to guarantee their performance. We would point out that the information contained in this leaflet is only a recommendation, and may need to be altered to suit the conditions and efficiency of the equipment employed.